Gateway S-7410M Optical Drive Installation/Replacement Instructions

Warning: Disconnect the power adapter, disconnect the modem and network cables, and remove the battery. Replace the cover before restoring power or reconnecting the modem and network cables.

Note: Before beginning, review electrostatic discharge (ESD) precautions.

Replacing the Optical Drive

1. Verify that the drive is empty.


2. Shut down the computer, close the LCD panel, and then disconnect the power adapter.


3. Disconnect the modem and network cables.


4. Disconnect all peripheral devices and remove any PC cards.


5. Disconnect your notebook from the optional port replicator.


6. Turn the computer over, and then remove the battery.
   1. Slide the battery lock to the unlock position.
   2. Slide the battery release latch.
   3. Slide the battery out of the bay.


7. Remove the lock screw for the optical drive bay.
   
8. Insert a small, straight wire, such as end of a paper clip into the emergency eject hole of the optical drive and press it until the tray ejects.
   


9. Gently guide the drive straight out of the bay.
   


10. Insert the new drive into the optical bay.
    


11. Tighten the lock screw for the optical drive bay.
    
    
12. Insert the battery, and then turn over the computer.


13. Reconnect the optional port replicator.


14. Connect the AC adapter, modem and network cables, open the lid, and then turn on the computer

Close Window    Print This Page